Field report NW-66 / M7 · sheet /operations

Operations & RestructuringFiled from the territory

FAA pauses Juniper router installations after nationwide ground stop

The FAA paused Juniper router installations after a nationwide ground stop stranded thousands. Two routers are under examination in Florida, while the root cause remains unresolved.

Grid
NW-66 / M7
Surveyed
November 18, 2026
Reading
3 min read
Correspondent
Sophie Lindqvist
FAA halts router installation following nationwide ground stop
Fig. NW-66 / M7FAA halts router installation following nationwide ground stop — RitaE / pixabay

Field notes

  1. An FAA spokesperson confirmed the Juniper router installation pause to ABC News on Tuesday.
  2. Thousands of passengers were stranded when the FAA grounded all flights nationwide on Friday.
  3. Two routers from Arkansas and Texas are under examination at an L3Harris laboratory in Florida.
  4. One Texas system had been replaced about three weeks before the incident.
  5. The FAA has not determined the root cause or announced when installations will resume.

By Sophie Lindqvist

The Federal Aviation Administration has paused installation of Juniper routers after last week's rare, hourslong nationwide ground stop (the order that grounded all flights), an agency spokesperson confirmed to ABC News on Tuesday. The action stranded thousands of passengers in airports, and the FAA said it issued the order out of precaution.

The pause stops further Juniper installations while the agency investigates two routers linked to the incident. It will remain in effect during that investigation. The FAA has announced neither a root cause nor a date for resuming the work, leaving the agency without a clear schedule.

What triggered Friday's ground stop?

Officials described the incident in three steps. Their account links an Arkansas installation to the nationwide flight halt:

  • Arkansas installation: Installing and activating a Juniper router at an FAA facility flooded the network with data.
  • System impact: The data load overwhelmed an older system and caused telecommunications problems.
  • Operational response: The FAA grounded all flights on Friday.

Transportation Secretary Sean Duffy told ABC's "This Week" on Sunday that crews were replacing outdated copper wire with fiber cables in El Dorado, Arkansas. He said the router communication believed to have caused the stop occurred during that work.

When the router in that area was turned on, Duffy said: "we saw that in Amarillo, Texas, a system we had replaced about three weeks earlier, that started to flood our system as well." The reference extended the inquiry to a second system and router.

The agency still has not explained how the activation produced flooding beyond the local installation. Investigators are examining the routers from Arkansas and Texas to determine what happened. That work has not yet produced a public finding.

Where is the investigation being conducted?

L3Harris is examining both routers at its laboratory in Florida. L3Harris is a government contractor that provides technology and information technology support to the FAA. It also worked with Juniper and Juniper's owner, Hewlett Packard Enterprise, to install the routers.

Juniper, Hewlett Packard Enterprise and L3Harris therefore all worked on the router installation. The public account does not assign any company a specific responsibility for the incident. That leaves the central technical cause unresolved despite Hewlett Packard Enterprise's assurance and the agency's incident chronology.

Did the routers malfunction?

A Hewlett Packard Enterprise spokesperson previously said its routers were working properly when the ground stop occurred. The company stated: "Based on what we know today, the device functioned as it was configured to by the installer. It did not fail or act improperly."

That assurance narrows the claim without supplying a complete answer. It addresses the device's configuration and behavior, but not why the data load overwhelmed the older system or reached the scale that grounded all flights.

The statement remains conditional, beginning with "Based on what we know today." The Florida laboratory examination has not produced a public finding that resolves that assurance.

What does the installation pause change?

For the FAA, the pause limits further installations while engineers inspect the two routers most closely associated with the incident. It is a containment measure, not proof that the wider network is sound.

For passengers and airlines, the immediate change concerns the technology program rather than a newly announced operating rule. The agency has provided no fresh flight guidance for airports, airlines or passengers beyond documenting Friday's ground stop and the resulting stranding. The FAA has not released a resumption schedule or a finding on responsibility.

Until the Florida examination identifies the cause, the defensible conclusion is narrow: the FAA has stopped expanding the router program. It has not yet explained how a device operating as configured triggered nationwide disruption.

via abc11.com (Source)

Share this article:

More from Sophie Lindqvist

Sophie Lindqvist

Show full bio

Correspondent covering money, funding and market shifts around corporate strategy and chief-executive leadership at CEO Frontier.

483 articles

Filed under

Adjacent sheets

« Previous articleNext article »

End of sheetNW-66 / M7 · November 18, 2026