Field report E-87 / Q5 · sheet /operations
Operations & RestructuringFiled from the territory
FAA Halts Juniper Router Rollout After Nationwide Ground Stop
The FAA has paused new Juniper router installations after a botched Arkansas switchover flooded aging Cisco servers, forcing a four-hour ground stop and canceling over 18,000 U.S. flights.
- Grid
- E-87 / Q5
- Surveyed
- November 18, 2026
- Reading
- 3 min read
- Correspondent
- Priya Raman

Field notes
- The FAA paused new Juniper router installations on Tuesday after Friday's nationwide ground stop.
- Friday's ground stop halted all U.S. flights for over four hours and canceled more than 18,000 flights.
- The failure began during an L3Harris equipment swap at an FAA radio site in El Dorado, Arkansas.
- Duffy said 2001-era Cisco servers, out of commission since 2006, flooded and destabilized the network.
- The FAA and DHS say a cyberattack is unlikely to be the cause; routers in Florida and Texas are under investigation.
The Federal Aviation Administration has paused new router installations after a modernization swap appears to have triggered last Friday's nationwide ground stop, which halted all U.S. flights for more than four hours and canceled over 18,000 of them. The agency announced the freeze on Tuesday while investigators work out exactly what went wrong.
The decision is a straightforward precaution. The FAA is replacing pieces of an air traffic control infrastructure that Transportation Secretary Sean Duffy describes as genuinely ancient — and one of those replacements misbehaved badly enough to knock a whole national network offline.
What actually failed?
The trouble started at an FAA radio communications site in El Dorado, Arkansas. There, contractor L3Harris Technologies was updating what Duffy called antique equipment with a new Juniper router — a network device that directs data traffic between systems.
The equipment being replaced was old in a way that's almost comical. Duffy said the systems in question "should have been taken out of service before your iPhone was even invented."
The new router didn't crash. Instead, according to Duffy, it flooded the network with traffic. And the parts of the system that couldn't cope were, ironically, the old ones: Cisco servers from 2001 that went out of commission in 2006.
"What happened was, as we did one of those switchovers in El Dorado, Arkansas, that server or that router started to flood our network," Duffy said in a CNBC interview on Monday. "Well, all of the work that I had done to put in new equipment, those routers in my system didn't go down. But we also use a lot of 2001 Cisco servers that went out of commission in 2006. It's those old servers that were flooded and started to give us inconsistency in our network."
That inconsistency is what forced the precautionary ground stop on Friday.
Is anyone blaming a cyberattack?
No — and that question has been asked directly. Both the FAA and the Department of Homeland Security have said cyberattacks are unlikely to be the cause of the historic outage. This looks like a technical failure born of old hardware meeting new hardware, not an intrusion.
Officials currently believe either the Juniper router itself or the way it was installed is to blame for the outage.
Why is the FAA pausing installations now?
Because the same failure pattern has shown up more than once. Duffy said the FAA and L3Harris Technologies are investigating the Juniper router in Florida, along with another router installed at a Texas FAA facility that also went haywire.
So the freeze pending further testing covers a rollout that has now produced at least two problem installations. The agency hasn't said how long the pause will last or how many sites were queued for upgrades.
How old is the system being replaced?
Old enough that Duffy framed his inheritance bluntly. "I was inheriting in a very old air traffic control system," he said. "It's old telecommunication, decades old. You know, radars from the '60s, really old radios … and what I've done is we're deploying radar and radios and equipment in our towers, and we're switching on our old telecom network. We're switching over from old copper wires to fiber."
That copper-to-fiber transition — moving data from legacy telephone-era wiring to modern optical cable — is the backdrop for the El Dorado switchover. The incident is a window into the risk profile of that migration: the new gear works, but the surrounding legacy hardware can buckle when it does.
What happens next?
Two investigations are running — one focused on the Florida router, another on the Texas installation — and the router rollout stays frozen until testing gives the all-clear. For now, the FAA's modernization push continues elsewhere: new radar, new radios, new tower equipment. Only the piece that broke the network on Friday is on hold.
The unanswered question is whether the fault sits with the router's design or with its installation. Until investigators settle that, every future switchover carries the same tail risk that grounded a nation for four hours on a Friday.
via washingtonexaminer.com (Source)
More from Priya Raman
Show full bio
Senior reporter covering technology and product news in corporate strategy and chief-executive leadership at CEO Frontier.
459 articles
Adjacent sheets
- FAA Pulls New Routers, Reverts to 25-Year-Old Cisco Gear After Ground Stop
- FAA Staff Challenge Official Story Behind Nationwide Ground Stop
- Duffy Demands $50 Billion From Congress After FAA Ground Stop
- Duffy Demands $50 Billion After FAA Outage Grounds US Flights
- One Router, 17 Centers, 6,500 Canceled Flights: The FAA Ground Stop Explained